Skip to content

Outdoor & Landscape Lighting

Outdoor lighting that gives the yard a second shift.

Holiday and permanent trim, deck and patio fixtures, retaining-wall washes, and repairs to systems that quit — designed for how your family uses the space after sunset, and aimed at night when it counts.

  • Holiday & permanent fixtures
  • Deck & patio lighting
  • Wall & retaining wall lights
  • Outdoor lighting repair

What we install

Four ways we light an outdoor space.

Most projects mix two or three of these. Everything below runs on one low-voltage system with a single transformer and schedule.

Holiday & permanent fixtures

Trim lighting you install once and run all year

Permanent roofline fixtures tuck into the eave and disappear in daylight, so there is no ladder in December and nothing to take down in January. Warm white handles everyday evenings; the same run turns red and green for the holidays, orange in October, or school colors on a Friday night.

Each point is individually addressable and controlled from an app — set a dusk-to-dawn schedule, pick a scene, and forget about it. If you would rather keep a traditional seasonal install, we also hang, service, and remove standard holiday lighting on a schedule.

  • App-controlled scenes, schedules, and dimming
  • Fixtures color-matched to fascia and gutter
  • Warm-white daily use, full color on demand

Deck & patio lighting

Light the floor, not people's eyes

Decks and patios need light low and pointed down: under-tread strips on the steps, post-cap fixtures along the rail, and small recessed lights washing the floor. The space stays usable after sunset without a single fixture glaring across the table.

We keep the wiring inside the frame and under the boards, so the finished deck looks exactly the way your builder left it — just visible at 10pm.

  • Step and stair lighting for safe footing
  • Rail, post-cap, and under-bench fixtures
  • Dimmable zones for dinner vs. party

Wall & retaining wall lights

Hardscape that keeps working after dark

A retaining wall is the best surface in most yards for light — texture, length, and a clean face to graze. Hardscape fixtures set under the cap course wash the block evenly, pull the stonework forward at night, and spill just enough light onto the patio below.

Because Betschart Lawn & Landscape builds these walls, we can drop conduit and sleeves during construction instead of drilling into a finished cap later. Already have a wall? We retrofit under existing caps with minimal disruption.

  • Under-cap hardscape lights and wall sconces
  • Sleeves and conduit set during wall construction
  • Column, pillar, and seat-wall accents

Outdoor lighting repair

Fix the system you already paid for

Most dead landscape lighting is not dead — it is a corroded connector, a nicked wire from an edger, an undersized transformer, or a photocell that gave up. We trace the run, meter the voltage at each fixture, and tell you plainly what is worth repairing and what is worth replacing.

We also retrofit older halogen systems to LED, which usually frees up enough transformer capacity to add the fixtures you have been wanting without pulling new wire.

  • Voltage testing and fault tracing on existing runs
  • Connector, wire, transformer, and timer repair
  • Halogen-to-LED retrofits and fixture replacement

Under the mulch

The part you never see is the part that lasts.

Low-voltage, safe around the family

Systems run on 12V through a properly sized transformer, so the wire in your beds is not a hazard to kids, pets, or the person with the spade.

Weather-resistant hardware

Sealed fixtures, gasketed connections, and wire buried at depth and routed clear of mower and edger paths — chosen to survive freeze-thaw and road salt.

Room to grow

We size the transformer with headroom so next season's fire pit, pergola, or new bed can be added to the same system instead of starting over.

How it works

Three visits, and the yard is done.

No deposit games, no vague estimates, and no leaving before the lights have been seen at night.

  1. Step 01

    Walk the property

    We visit at no charge, listen to how you actually use the yard, and note the trees, walls, and gathering spots worth lighting — plus the windows that should never catch a beam.

  2. Step 02

    Design the layout

    You get a fixture-by-fixture plan with zones, wire runs, transformer sizing, and a flat quote. No surprise change orders once the shovels are out.

  3. Step 03

    Install & dial in at night

    We install, bury the wire, and then come back after sunset to aim every fixture, set the timers, and adjust levels with you standing in the yard.

Adding cameras or outdoor audio at the same time? Cameras and outdoor audio share the same trenches and the same visit — it costs less to run them together than to come back next spring.

Straight answers

What people ask before the first walkthrough.

If yours is not here, ask it on the walk — we would rather talk you out of a fixture than sell you one you did not need.

What's the difference between holiday lights and permanent trim lighting?
Permanent roofline fixtures tuck into the eave and disappear in daylight, so there is no ladder in December and nothing to take down in January. Warm white handles everyday evenings, and the same run turns red and green for the holidays, orange in October, or school colors on a Friday night. If you would rather keep a traditional seasonal install instead, we also hang, service, and remove standard holiday lighting on a schedule.
Will you fix a lighting system somebody else installed?
Yes — most dead landscape lighting is not actually dead. It is usually a corroded connector, a nicked wire from an edger, an undersized transformer, or a photocell that gave up. We trace the run, meter the voltage at each fixture, and tell you plainly what is worth repairing and what is worth replacing. We also retrofit older halogen systems to LED, which usually frees up enough transformer capacity to add fixtures without pulling new wire.
Is low-voltage wiring safe with kids and pets in the yard?
That is a large part of why we use it. Systems run on 12V through a properly sized transformer, so the wire in your beds is not a hazard to kids, pets, or the person with the spade. The runs are buried at depth, routed clear of mower and edger paths, and every junction is gasketed so freeze-thaw and road salt do not work their way in.
Why do you come back at night to finish the job?
Because aiming a fixture in daylight is guesswork. After the install and the wire burial, we return after sunset to aim every fixture, set the timers, and adjust levels with you standing in the yard — which is also when it is obvious whether a beam is catching a window it should never catch.

Let's see what your yard looks like lit.

Free on-site lighting design across the Greater Pittsburgh area. Call (412) 853-7611 or send a few details and we'll set up a walkthrough.